EZTrim EZ PRESS PRO 12 Ton Hydraulic Rosin Tech Press
EZTRIM’s EZ Press uses heat and pressure for extraction that enables up to 60% yields
. No need for butane, co2, purging or heavy equipment that is dangerous to use. EZ Press is the world’s best rosin press. The EZ Press has 2 heat plates that are individually controlled with a thermocouple and controller. The Ez Press is a manual press
. The benefit of pressing manually is that it allows you to control the amount of pressure over time.
We have found that pneumatic pressing tends to press to quickly, causing blown out tubes and lower yields. The EZ Press was also designed to get the rosin off the heat as quickly as possible to avoid burning the product. The micron tubes are exactly the same width and length of the heat plates. This forces the product off of the heat as soon as you squish. The EZ Press can press over 1 oz of product at a time and can create up to 60% yields. The EZ Press also has the most pressure on the market at a true 12 tons.
- Power on the unit
- Set the temperature to 150°-200° F for both plates (temp is preset at factory to 170° F)
- Fill the micron tubes with 1 oz. of product
- Distribute the product evenly through the tube
- Fold over 2” of the tube at the open end
- Place the tube between 2 sheets of parchment paper
- Place the tube and parchment paper centered over the heat plate
- Release piston until raised to its highest point and tighten release screw
- With full top/bottom strokes pump the jack 21 – 23 times. Do not exceed 23 full pumps on the jack as it can damage the frame
- Hold in the pressed position for 30sec. to 1 minute
- Release the heat plates until the piston rises to its highest point and remove the parchment paper and tubes
- Empty the micron tubes and repeat steps 3 – 11
- The heat plate is 3” x 12” 76.2mm x 304.8mm
- Assembled Dimensions – L 26" W 19.5" H 48.5"
- Only 100 lbs
- 1 lb / hour finished product up to 60% yields